Filter
Top Products
11
Connecting to the Resolv sub88 Subwoofer
MediaOne Series with Optional Resolv sub88
Connecting an optional sub woofer like the Samson Resolv sub88 is easy using the
sub88's LINE LEVEL inputs. Below is a typical system set-up using the sub88 with a
mixer and a pair of MediaOne as satellites. The sub88’s inputs and outputs utilize indus-
try standard RCA connectors. For a detailed wiring diagram, see the section “MediaOne
Connections” on page 12. Follow the steps in the diagram below to set up your system.
• Lower your mixer or computer’s master outputs volume control to all the way off.
• Connect the mixer or computer’s left output to the sub88’s LEFT LINE INPUT and
the mixer’s right output to the sub88’s RIGHT LINE INPUT. Now, connect the sub88’s
LEFT and RIGHT LINE OUTPUTs to the RCA INPUTs of the right side MediaOne.
• Now adjust the SWEEP control to the desired frequency. A good place to start with
the MediaOne Series is about 70 Hz. (10 O'clock). You can also use your ears by
adjusting the SWEEP control to the frequency that sounds good to you.
• Run an audio signal (like some music from a CD) through your mixer or computer
and raise the level to a comfortable listening level. Now slowly raise the sub88’s
SUB VOLUME control and listen to the low frequency output. Adjust the sub88 to
the level of low frequency output that you like. Now, when you raise and lower
your mixer’s output, the sub88 and MediaOne Series will track at the same relative
volume.
ENGLISH