Filter
Top Products
WALL MOUNTING WITH ADHESIVE
1. Select a spot on the wall that is as smooth as possible, such as a
smooth ceramic tile. Thoroughly clean the spot of all soap, oil or
other films using a household cleaning solvent such as Acetone or
nail polish remover. DO NOT use the tile cleaner or other wax-
based substances. Allow area to dry completely. Room
temperature should be at 60 to 70ºF.
2. For best results, hold adhesive tube (supplied) at a 45-degree angle
and apply sealant to Mounting Plate, approximately 1/8” bead and
1/4” from edges. Use entire contents. If additional adhesive is
required, use silicone caulking compound or you may order extra
adhesive packets. (P/N 01005)
3. Place Mounting Plate against clean wall surface using enough
pressure to displace air, but not adhesive.
4. Allow adhesive to cure for 24 hours.
5. Slide the Radio onto the secured Mounting Plate.
WALL MOUNTING WITH SCREWS
1. Place Mounting Plate against a clean wall surface and mark the
spots on the wall where you will be drilling. Remove the Mounting
Plate from the wall.
2. Drill 4 holes in the wall that match the placement of the holes in the
Mounting Plate.
3. Insert a Screw Socket into each of the 4 holes.
4. Place Mounting Plate against the wall in the correct position and
drill in the 4 Screws.
5. Slide the Radio onto the secured Mounting Plate.
*Color reference: BL, OR, PL, RD, GY, PB.
3
4 Mounting
Screws
4 Screw
Sockets
Wall
Mounting
Plate
(10040*)
Earphone
Jack
Adhesive
Bead
Mounting
Plate
(10040*)
WALL MOUNTING WITH SCREWSWALL MOUNTING WITH ADHESIVE
Wall
Earphone
Jack