Filter
Top Products
INSTALLATION OPTIONS:
ATTACHING THE HOOK
1. Put the Hook Screw into the round hole
on the Hook and then lift the Hook
upwards until the Screw slides into the
smaller groove on the Hook.
2. Place Hook with Radio securely
attached onto your shower head pipe.
WALL MOUNTING
WITH ADHESIVE
1. Select a spot on the wall that is as
smooth as possible, such as a smooth
ceramic tile. Thoroughly clean the spot
of all soap, oil or other films using a
household cleaning solvent such as
Acetone or nail polish remover. DO
NOT use tile cleaner or other wax-
based substances. Allow area to dry
completely. Room temperature should
be at 60 to 70ºF.
2. For best results, hold Wall Adhesive
Packet (supplied in package) at a 45-
degree angle and apply sealant to
Mounting Plate, approximately 1/8”
bead and 1/4” from edges. Use
entire contents.
3. Place Mounting Plate against clean
wall surface using enough pressure
to displace air, but not adhesive.
4. Allow the Adhesive to cure for 24 hrs.
5. Slide the Radio onto the secured
Mounting Plate.
WALL MOUNTING WITH SCREWS
1. Place Mounting Plate against a clean
wall surface and mark the spots on the
wall where you will be drilling. Remove
the Mounting Plate from the wall.
2. Drill 4 holes in the wall that match
the placement of the holes in the
Mounting Plate.
3. Insert a Screw Socket into
each of the 4 holes.
4. Place Mounting Plate
against the wall in the
correct position and
drill in the 4 Screws.
5. Slide the Radio
onto the secured
Mounting Plate.
Congratulations! You are the proud owner of the Scooby Doo
Shower Radio. To obtain maximum satisfaction and enjoyment,
please follow these simple guidelines.
1. Do not submerge the Scooby Doo Shower Radio in water. It is
water resistant, not waterproof!
2. Insert 3 AA ALKALINE batteries (not included) into the
Battery Compartment.
3. Signal Reception.
Turn on the Radio and move it around to various locations and
positions on the wall to determine a suitable location that provides
good reception.
Avoid locations that lie directly in the path of the shower stream.
1
OPERATING INSTRUCTIONS
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS
Mounting Plate
(P/N 10028)
Volume
Control
Dial
AM/FM
Switch
4 Mounting
Screws
4 Screw
Sockets
4 Mounting
Screws
4 Screw
Sockets
Radio
Tuning
Dial
Hook
(P/N 10029)
Wall
Adhesive
Packet
(P/N 01005)
Wall
Mounting
Plate
Adhesive
Bead
Battery
Compartment
Hook
Screw
Hook
Mounting
Plate
ATTACHING THE HOOK
WALL MOUNTING
WITH SCREWS
WALL MOUNTING
WITH ADHESIVE
Wall
salton
™
WALL
ADHESIVE
2
SD8SR_Manual_20-8-01 20/8/01 12:51 Page 1