Filter
Top Products
ESTABLISHING THE WIRELESS
CONNECTION
On both the headphones and wireless transmitter slide the power switches to the
“ON” position - both units must be powered up in order to establish a connection.
On power up, the LEDs on the units flash red/blue while they are looking to pair. On
successfully establishing a connection, the LEDs flash blue 5 times,and 3 beeps will be
heard in the headphones.
If the connection has not been established, the LED will flash red 5 times. Press the
pairing button on the transmitter unit once to restart the connection process.
.
PLAYING MUSIC
Press play on your PC’s Media player, CD-player, iPod or other MP3 player.
Press the volume up or down buttons on each side of the headphones to
increase or decrease volume.There are 10 volume levels.
CONNECTING THE WIRELESS
TRANSMITTER
Insert the wireless headphone transmitter's 3.5mm jackplug
into the audio out or headphone socket of your computer,
CD-player, iPod or other MP3 player.
POWERING UP
The headphones and transmitter are supplied partially charged and will work out of
the box. However, we recommend that you charge them fully before use.
To charge the units, connect them to the Y-splitter cable and connect the cable to the
mains adapter. During charging, the LED will stay red, changing to green when fully
charged.The units will be 80 percent charged in approximately one hour and fully
charged in two hours.
To turn the headphones and transmitter on, slide the switches on each to the “ON”
position.
dmeQSGA350.qxd 11/2/2005 12:40 PM Page 4