Control Functions
11
MEMORY PROCEDURE
MEMORY allows for permanent storage of zone
settings. Source, volume level, bass level, treble
level, loudness, paging volume, and "SYSTEM
ON disable" settings can be stored. Once
stored, these settings can be accessed by
pressing PRESET.
To set MEMORY for a single zone:
1. Select a zone using the ZONE SELECT.
2. Adjust zone as desired.
3. Press MEMORY. The MEMORY indicator will
light.
4. To store VOLUME, BASS, and TREBLE levels,
press the ▲ (up) button for the correspon-
ding function.
5. To store current input source, press any
source
button.
6. To store loudness setting, press LOUDNESS.
7. To prevent the zone from turning on when All
On is activated, press SYSTEM ON.
8. To preset paging volume, press VOLUME ▼
(down)
9. To exit, press MEMORY again. The MEMORY
indicator should no longer be illuminated.
To clear MEMORY for a single
zone:
1. Select a zone using ZONE SELECT.
2. Press MEMORY followed by PRESET.
3. Press MEMORY again to exit.
To clear MEMORY for all
zones:
1. Press MEMORY followed by SYSTEM OFF.
PRESET PROCEDURE
PRESET recalls settings for the current zone pre-
viously stored in memory. A preset can be
recalled at the PR-4Zi front panel, on a PCK(IR)
keypad, or via the PRC-1 remote control.
1. Select a zone using ZONE SELECT.
2. Press PRESET.
Pressing PRESET on a PCK keypad or PRC-1
remote control will recall the settings for that
local zone.
PARTY MODE
Two PARTY modes allow synchronous operation
of all zones.
Source Link mode. Activated upon pressing
PARTY once. Source settings are linked for all
zones. Any changes to source selection at the
PR-4Zi front panel will be made simultaneously in
all zones. However, zone volumes can be adjust-
ed independently.
Source Link mode procedure:
1. Set Zone 1 volume and source as desired for
the entire system. Turn on each zone you
want to include for PARTY mode.
2. Press PARTY once
. The SOURCE LINK indica-
tor will light and the settings made for Zone 1
will be reflected in all other zones currently
turned on.
Source/Volume Link mode. Activated upon
pressing PARTY twice. Source and volume set-
tings are linked for all zones. Any changes to
source selection or volume in one zone will be
made simultaneously in all others.
Source/Volume Link mode procedure:
1. Repeat Step 1 above.
2. Press PARTY twice
. The SOURCE/VOL LINK
indicator will light and the settings made for
Zone 1 will be reflected in all other zones cur-
rently turned on.
Refer to Figure 9 at left for the following procedures.
PR-4Zi manual 6/18/02 12:58 PM Page 11