Filter
Top Products
6
6. SPECIFICATIONS
Audio power output: Continuous 50W @ 8 ohms, 75W @ 4 ohms.
Frequency response: 20HZ to 20KHZ -0.3dB.
Total harmonic distortion: 0.05% 8 Ohm, .075% 4 Ohm
Input sensitivity: 400mV line
Input impedance: 22k Line Input
Signal to noise ratio: 85dB
Input trigger: 12VDC 10k
Output trigger: 12VDC 150mA
Auto off delay time: 2 to 10 minutes
Primary fuse: T4A/250V 115VAC, T2A/250V 240VAC
Secondary fuse: T6.3A/250V
Power requirements: Factory set for 110 VAC 60Hz or 240 VAC 50Hz. IEC 320 type connector with
3 terminal detachable power cord. For 240VAC operation, use a power cord
(not supplied) rated for 240VAC 6.3 amps or higher.
Weight: 46 lbs.
Dimensions: 19" W x 17"D x 7.5"H
7. WARRANTY
The Russound DPA-6.12 is fully guaranteed for two (2) years from the date of purchase against all defects in
materials and workmanship. During this period Russound will replace any defective parts and correct any defect
in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and
used according to its written instructions. If service is necessary, it must be performed by Russound. The unit must
be returned to Russound at the owners expense and with prior written permission. Accidental damage and ship-
ping damage are not considered defects under the terms of the warranty. Russound assumes no responsibility for
defects resulting from abuse or servicing performed by an agency or person not specifically authorized in writing
by Russound. Damage to or destruction of components due to improper use voids the warranty. In these cases
the repair will be made at the owners expense. To return for repairs, the unit must be shipped to Russound at the
owners expense, along with a note explaining the nature of the service required. Be sure to pack in a corrugated
container with at least 3 inches of resilient material to protect the unit from damage in transit.