Filter
Top Products
Installation
Runco LS-3/LS-5 Installation/Operation Manual 31
PRE
L
IMINAR
Y
Connecting to AC PowerThe LS-3/LS-5 ships with various types of AC power cords. Choose the one that is
appropriate to your locale.
Plug the female end of the power cord into the AC receptacle on the rear of the projector
(AC 100V ~ 240V); see
Figure 2-3. Then, connect the other end to your AC power source.
3.7
Turning on the Power
1. Turn on your source components.
2. Press the ON button on the remote control to turn on the LS-3/LS-5. The LED
flashes green to indicate that it is warming up.
3. When the projector is ready for use, the LED turns off.
3.8
Lens Adjustments
The LS-3/LS-5 gives you a great deal of control over the picture size, position and focus.
Focus and ZoomTo focus the projected image, grasp the lens
by the front ring and rotate it.
To make the picture smaller (zoom out) or
larger (zoom in), rotate the zoom ring in the
appropriate direction.
Lens ShiftTo access the lens shift controls:
1. Locate the Runco badge at the top of the
projector. Press on the side of the badge
nearest the “R” to release it.
2. Carefully lift the badge up, then away from
the projector.
ON
l
Zoom Out
Zoom In
Focus