Filter
Top Products
8
Making the Connections
Refer to the figure shown below to connect the KC-60 and the other equipment.
fig.03
Here is an example of a setup that makes full use of the KC-
60’s mixer and monitor functions.
A microphone is input to CH 1, which accepts mic level
input. Connect a keyboard, recorder, or other sound-
generating device to the CH 2 and CH 3 inputs.
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections. Set all of the KC-
60’s channel volume knobs as well as the VOLUME knob to
zero.
* The pin assignment for the XLR type connectors is as shown
below. Before making any connections, make sure that this pin
assignment is compatible with that of all your other devices.
fig.04
* Howling could be produced depending on the location of
microphone relative to speakers. This can be remedied by:
1. Changing the orientation of the microphone.
2. Relocating microphone at a greater distance from the speaker.
3. Lowering volume levels.
* When connection cables with resistors are used, the volume level
of equipment connected to the inputs (CH 1 through CH 3 and
AUX IN) may be low.
If this happens, use connection cables that do not contain
resistors, such as those from the Roland PCS series.
INPUTINPUT
OUTPUT OUTPUT
Rear PanelControl Panel
Mixer
Subwoofer
(With built-in amp)
Stereo
Headphone
Microphone
Drum Machine
CD Player
Keyboard