Filter
Top Products
7
Specifications
Rated Power output
120 W (60 W + 60 W) / 8
Ω
+ 8
Ω
Speakers
30 cm (12 inches) + 30 cm (12 inches)
Power Supply
AC 117 V, AC 230 V or AC 240 V
Power Consumption
110 W (117 V, 230 V, 230 VE, 240 VA)
Nominal Input Level
-30 dBm / 680 k
Ω
0 dBm = 0.775 V
Connectors
CH-1 Input Jacks (HIGH, LOW)
CH-2 Input Jacks (HIGH, LOW), FOOT SWITCH Jacks
(CHORUS/VIBRATO, REVERB, and DISTORTION)
CH-2 EFFECT LOOP SEND Jack
CH-2 EFFECT LOOP RETURN Jacks (L (MONO), R)
LINE OUT Jacks (L (MONO), R)
Controls
CH-1: BRI (Bright) Switch, VOLUME Knob, TREBLE Control Knob,
MIDDLE Control Knob, BASS Control Knob
CH-2: BRI (Bright) Switch, VOLUME Knob, TREBLE Control Knob,
MIDDLE Control Knob, BASS Control Knob, DISTORTION Knob,
REVERB Knob, Vibrato SPEED Knob, Vibrato DEPTH Knob,
VIB/OFF/CHORUS Switch
POWER Switch, CH-2 EFFECT LOOP Switch, CH-2 EFFECT LOOP LEVEL Switch
Dimensions
760 (W) x 280 (D) x 622 (H) mm (includes casters)
29-15/16 (W) x 11-1/16 (D) x 24-1/2 (H) inches
Weight
31.2 kg / 68 lbs 13 oz
Accessories
Owner’s Manual
Options
Foot switch: FS-5L (BOSS)
* In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice.
For the USA
FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Unauthorized changes or modification to this system can void the users authority to operate this equipment.
This equipment requires shielded interface cables in order to meet FCC class B Limit.
For Canada
CLASS B
This digital apparatus does not exceed the Class B limits for radio noise emissions set out in the Radio Interference
Regulations of the Canadian Department of Communications.
CLASSE B
Cet appareil numérique ne dépasse pas les limites de la classe B au niveau des émissions de bruits radioélectriques
fixés dans le Règlement des signaux parasites par le ministère canadien des Communications.
NOTICE
AVIS
For Europe
This product complies with the requirements of European Directive 89/336/EEC.