Filter
Top Products
8
Panel Descriptions
Rear Panel
1. FOOT SW (Foot Switch) Jack
Foot switches (the optional BOSS FS-5U) are connected here.
* Set the polarity switch as shown below.
fig.06
(CH SELECT)
Switches JC CLEAN/LEAD channels.
(EFX)
Switches on and off of EFX.
(DELAY/REVERB)
Switches on and off of DELAY/REVERB.
2. EXT SPEAKER (External Speaker) Jack
You can connect external speaker here.
When connected, sounds are played from both the CUBE-60
and the external speakers.
* When connecting to an external speaker, make sure the speaker
conforms to the following specifications.
Impedance: 8
Ω
maximum
Allowable power input: 60 watts minimum
* Only use speaker cable to connect the speaker. Do not use any
shielded cable designed for use with guitars.
* No sound is output from the CUBE-60’s speaker or any external
speaker when the RECORDING OUT/PHONES jack is in use.
3. LINE OUT Jack
Connects to a PA system, recorder, or other external system.
The COSM speaker modeling allows the guitar amp to
produce sounds with real punch.
Use this when using the unit with an external PA system or
when line-recording performances while listening to the
sound from the CUBE-60’s speaker.
Adjust the output level with the JC CLEAN channel or
LEAD channel VOLUME knob.
4. TUNER OUT Jack
Connect tuner to this jack.
* The output from here is unaffected by the CUBE-60’s knob and
switch settings.
................................................................................................................
Q:
The volume level of the instrument connected to the CUBE-
60 is too low.
A:
Could you be using a connection cable that contains a resistor?
Use a connection cable that does not contain a resistor.
................................................................................................................
INPUT
Mixer
Speaker
cable
Tuner
External Speaker
INPUT
INPUT
INPUT
FS-5U FS-5U FS-5U
31 42
Polarity switch
CUBE-60_e.book 8 ページ ２００４年３月５日 金曜日 午後４時４１分