Roksan Audio FR - 5 Speaker User Manual


 
Roksan Audio ltd Caspian FR-5 Loudspeaker User Manual
CLASSIFICATION: General Use Version: 1.07
All specifications are liable to change without notice. E&OE Page 6 of 12 ENGLISH
C
C
O
O
N
N
N
N
E
E
C
C
T
T
I
I
N
N
G
G
L
L
O
O
U
U
D
D
S
S
P
P
E
E
A
A
K
K
E
E
R
R
C
C
A
A
B
B
L
L
E
E
S
S
C
C
o
o
n
n
v
v
e
e
n
n
t
t
i
i
o
o
n
n
a
a
l
l
Please refer to rear terminal panel view on Page 4. There are two sets of terminals the upper set corresponds to
the tweeter and the lower to the woofers. There is a small illustration printed on the rear label for your reference.
The Caspian FR-5 Loudspeaker comes supplied with a set of two removable ‘jump-bars’ already connected. To
connect the loudspeaker conventionally, simply attach your speaker cable to the lower set of terminals marked
‘woofer’. Make sure that both loudspeakers of the pair are connected in the correct polarity with respect to the
output terminals of your amplifier:
RIGHT
Ä
Ä RIGHT and LEFT
Ä
Ä LEFT
and RED
Ä
Ä
RED and BLACK
Ä
Ä
BLACK
or
+ve
Ä
Ä +ve and -ve
Ä
Ä -ve
SETUP Cas
p
ianFR-5 Louds
p
eaker
IMPORTANT NOTE:
Always switch the Amplifiers OFF before attempting to connect or disconnect the speaker cables
to/from your loudspeakers. Failure to do this may cause permanent damage to the amplifier and/or
the louds
p
eakers.
1
NOTE:
For optimum performance it is recommended to use high quality cables such as ROKSAN HDC-
02S High Definition Speaker Cable. Many speaker cables such as the ROKSAN HDC-02S are
directional. Please observe this directionality. DO NOT use speaker cable with conductor size less
than 16 AWG (1.6mm Diameter). The Binding posts accept conductor sizes up to 12 AWG.
1
C
C
o
o
n
n
v
v
e
e
n
n
t
t
i
i
o
o
n
n
a
a
l
l
AMPLIFIER
NOTE:
‘Jump-
bars’
Connected
1
NOTE:
To assist setup, do not fit the speaker spikes yet. This will be done after the optimum
position/location of the speakers in the room is established.
1