Filter
Top Products
1. Power LED (Top of unit) – This Blue LED illuminates when the unit is turned on.
2. Thermal LED (Top of unit) – This Red LED illuminates if the amplifier reaches the third stage of
thermal protection.The amplifier will shut down to cool if this occurs.
3. Protect LED (Top of unit) – This Yellow LED illuminates if a short circuit or too low of an impedance
is detected at the speaker connections.The amplifier will automatically shut down if this occurs.
4. Cast Aluminum Heatsink – The cast aluminum heatsink of the Punch amplifier dissipates heat
generated by the amplifier's circuitry.
5. Speaker Terminals – The heavy duty, nickel-plated clamp wire connectors (
+
and -) will accept wire
sizes from 8 AWG to 18 AWG.Speaker outputs A and B are wired in parallel internally.
6. Remote Bass – Boosts low frequency information to overcome road noise and put the bass in your
face.The Remote Bass control is a narrow band adjustment at 45Hz variable from 0dB to +18dB with a
Gyrator based Punch EQ that eliminates frequency shift with boost.Connection is made with a RJ-45
cable and can be installed in a variety of ways for easy control access.An optional Para-Punch Remote
Bass is available which adds an adjustable center frequency control with the adjustable boost control.
7. Gain Control – The input gain control is preset to match the output of most source units. It can be
adjusted to match output levels from a variety of source units.
8. Variable Crossover (P325.1) – Is a built-in 12dB/octave Butterworth filter selectable for High-Pass
(HP),All Pass (AP), or Low-Pass (LP) operation variable from 40Hz to 400Hz.
8. Variable Crossover (P600.1 bd) – Is a built-in 12dB/octave Butterworth filter with a crossover
point variable from 35Hz to 250Hz.The crossover is set to Low-Pass (LP).
9. RCA Input Jacks – The industry standard RCA jacks provide an easy connection for signal level input.
They are nickel-plated to resist the signal degradation caused by corrosion.
10. RCA Pass-Thru Jacks – The Pass-Thru provides a convenient source for daisy-chaining an additional
amplifier without running an extra set of RCA cables from the front of the vehicle to the rear amplifier
location.
11. REM Terminal – The heavy duty, nickel-plated captive c-clamp wire connector will accept wire sizes
from 12 AWG to 24 AWG.This terminal is used to remotely turn-on and turn-off the amplifier when
+12V DC is applied.
4
DESIGN FEATURES
Connections