Filter
Top Products
4
DESIGN FEATURES
INSTALLATION
1. DSP LCD Display – Title screen when amplifier is turned on. Shows menus, sub-menus and
selections during DSP set-up.
2. (up) and (down) Keys – Use to scroll menus and sub-menus as well as making
adjustments during DSP set-up.
3. (left) Key – Use to back up one step in adjustments or menus during DSP set-up.
4. (right) Key – Use to enter into menus and sub-menus during DSP set-up.
5. Select Key – Use to select into menus, sub-menus and for finalizing adjustments during
DSP set-up.
6. Cast Aluminum Heatsink – The cast aluminum heatsink of the amplifier dissipates heat
generated by the amplifier's circuitry. The inherent advantage of this casting design optimizes
cooling and thermal performance.
7. Power Terminals – The power and ground connectors are platinum-plated and will
accommodate up to 4 AWG wire maximizing the input current capability of the amplifier.
8.
REM Terminal – This terminal is used to remotely turn-on and turn-off the amplifier when +12V
DC is applied.
9. Speaker Terminals – The heavy duty, platinum-plated terminal block connectors (+ and –) will
accept wire sizes from 8 AWG to 18 AWG. These platinum-plated connectors are immune to
corrosion that can cause signal deterioration.
10. RCA Input Jacks – The industry standard RCA jacks provide an easy connection for signal level
input. They are platinum-plated to resist the signal degradation caused by corrosion.
11. RCA Pass-Thru/Auxiliary Output Jacks – The Pass-Thru/Auxiliary Output provides a convenient
source for daisy-chaining an additional amplifier without running an extra set of RCA cables
from the front of the vehicle to the rear amplifier location.
INSTALLATION CONSIDERATIONS
The following is a list of tools needed for installation:
Volt/Ohm Meter
Wire strippers
Wire crimpers
Wire cutters
#2 Phillips screwdriver
Battery post wrench
Hand held drill w/assorted bits
1/8" diameter heatshrink tubing
Assorted connectors
Adequate Length—Red Power Wire
Adequate Length—Auto Power Wire
Adequate Length—Black Grounding Wire
Top of
Amplifier