Filter
Top Products
– 19 –
U
SING
THE
50.2 S
IGNAL
S
WITCHING
N
ETWORK
The Punch 50.2 Power amplifier has a crossover switching network which enables you to:
• “Audiophile Bypass” the 50.2 and Pass-Thru
• Configure a 12dB per octave filter for both 50.2
and Pass-Thru
• “Audiophile Bypass” the 50.2 and configure a 12dB per octave filter for the Pass-Thru
• Configure a 24dB per octave filter for the 50.2 and “Audiophile Bypass” the Pass-Thru
• Configure a 12dB per octave bandpass filter for the 50.2 and “Audiophile Bypass” the Pass-Thru
The crossover switching network allows the crossover to be distributed to the amplifier and Pass Thru in many different
configurations. The orientation of both switches configure the distribution pattern to where the crossover signal will
be routed.
I
N
S
T
A
L
L
A
T
I
O
N
® ®
POWER
50.
2
Low-Pass
Full Range
High-Pass
HP
LP
HP
LP
FULL
XCard Options
XCard 1 XCard 2
Amplifier
Pass Thru
Amplifier Amplifier
XCard 1 XCard 2
XCard 1
XCard 2
*Bridging Note: The Punch 50.2 can be
bridged in many configurations. Refer to your
owner's manual to determine which mode
will work best in your system.
ROCKFORD CORPORATION
MADE IN THE USA
®
25 Watts X 2 into 4 Ohms
with less than 0.05% THD + N from 20-20kHz
50 Watts X 2 into 2 Ohms
with less than 0.10% THD + N from 20-20kHz
®
AMPLIFIER
XCard 1 XCard 2
XCard 1 XCard 2
Audiophile Bypass
Not Used Not Used
Audiophile Bypass
Not Used
Amp Only
Pass Thru