Filter
Top Products
2. For the Punch 4040, place the protective boot onto
the wire. Insert the wire into one end of the fuse holder
so that the insulation is just inside the crimp area as
shown in the diagram. Crimp the wire in place with the
notched portion of a crimping tool. Cover the crimped
area with the protective boot that is supplied with the
fuse holder.
11
Fuse Holder
Protective Boot
Crimp Here
{
3. For the Punch 4080, place the protective boot onto
the wire. Slide the wire into the wire sleeve. Making
sure the screw holes on the wire sleeve and fuse
holder align, insert the prepared wire sleeve into the
smaller end of the fuse connector. Tighten the wire in
place with the enclosed allen screw. Screw the pro-
tective boot onto the fuse holder.
wire
4. Repeat the above steps to connect the remainder of
the red power wire to the other side of the fuse holder
and route to the amplifier mounting location.
wire
fuse connector
wire sleeve