Filter
Top Products
13RF-WHTIB
Using your universal wireless rear speaker
kit
Establishing communications between the sender and
receiver
To turn on the System:
1 Press the (power) button on the back panel of the sender. The LED
indicator blinks to indicate that the sender is plugged in and in Standby
mode.
2 Press the (power) button on the back panel of the receiver. The LED
indicator blinks to indicate that the receiver is plugged in and in Standby
mode.
The sender and receiver were pre-paired at the factory. When an active
link is established between them, the LED indicators turn solid.
Note: In case the indicators continue to blink after 30 seconds, it means there is no
active link between the sender and receiver. Try to connect the system manually
using the CONNECT button. For more information, see “Troubleshooting” on page
15.
Listening to the system
To listen to the system:
1 Power on the system. Make sure that there is an active link between the
sender and receiver.
2 Turn on your amplifier, then play the audio or video source through your
amplifier.
Blinking LED
Blinking LED