Filter
Top Products
18
Note: Rocketboost devices have their own memory. After the devices are paired once,
they will remember each other and pair automatically when they are powered on
again. Because of this, you can pair all of your network components in the same
room before installing them in their permanent locations throughout the house.
Listening to music
To listen to music:
1 Turn on the audio source connected to the Rocketboost wireless sender.
Make sure the volume of the audio source is turned up and not muted,
otherwise no audio will be sent over the Rocketboost network.
2 Turn on the wireless sender and wireless receiver. The power indicator
LEDs should light steadily. If they are blinking you need to re-pair the
wireless sender and wireless receiver. See “Establishing communication”
on page 17.
3 Play music from the audio device connected to your wireless sender and
listen to it from speakers attached to the wireless receiver.
4 Adjust the volume level on your wireless receiver. If you have multiple
audio sources in your Rocketboost network, press the SOURCE button on
the wireless receiver to hear the next audio source. Press the SOURCE
button again to cycle through all available audio sources.
Controlling the device volume
The volume of the wireless receiver can be changed.
To change the volume of the wireless receiver:
• Aim the remote control at the wireless receiver and press the DEVICE
volume buttons on the remote control, or turn the volume knob on the
wireless receiver to adjust the volume.
TM
TM
RF-RBREC_10-1328_MAN_V5.fm Page 18 Wednesday, November 9, 2011 8:40 AM