Filter
Top Products
19
Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough
to give good reception. However, you may wish the Auto-scan function
to also be able to fi nd weaker signals, possibly from more distant radio
transmitters. Your radio includes a local / distant option for the Auto-scan
function.
1. Press the On/Off button to switch on your radio.
2. If needed, press the DAB/FM button to select the FM band.
3. Press and hold the Info button until the display shows 'FM Scan Zone'
then press the Tuning control to enter the scan zone selection menu.
4. Rotate the Tuning control to switch between Local and Distant options
on the lower line of the display. The Distant option will allow the radio
to fi nd weaker signals when scanning.
The currently stored setting will be shown with an asterisk on the
display.
5. Press and release the Tuning control to confi rm your selection. The
radio will then revert to the normal information display. The Local or
Distant setting is stored in the radio and remains in force until changed
or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
2
1
3
3-5