Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
6
Using the sound system for the fi rst time
1. Place your sound system on a fl at surface.
2. Fully extend the telescopic aerial. The aerial should be fully extended
and positioned vertically for optimum reception.
3. Insert the adaptor plug into the DC socket located on the rear of your
sound system. Plug the adaptor into a standard 13 amp mains socket
outlet. The display will show "ROBERTS" for a few seconds and then
the display will then show "SET CLOCK". After a short time the current
time will appear on the display.
4. If no stations are found, "NO CLOCK" will be displayed. It may be
necessary to relocate your sound system to a position giving better
reception. You should then carry out a scan to fi nd stations as described on
page 11.
IMPORTANT: The mains adaptor is used as the means of connecting the
sound system to the mains supply. The mains socket used for the sound
system must remain accessible during normal use. In order to disconnect
the sound system from the mains completely, the mains adaptor should
be removed from the mains socket outlet completely.
Characters appearing on the LCD display indicate that the sound system
is connected to and powered from the mains supply.