Filter
Top Products
Listening to the radio - FM
1. Set the Function switch to the 'Radio' position. The Operation
indicator will light up.
2. Select 'FM' using the Waveband switch.
3. Adjust the Volume control until a hissing sound is heard.
4. The Telescopic aerial which is only operational on FM, should be
fully extended.
5. Carefully tune to the desired station using the Tuning control.
6. Angle and rotate the Telescopic aerial to a position giving the best
reception. A knuckle joint at the base of the aerial allows this
movement and an angle of 45 degrees will usually be satisfactory.
The FM band is marked in Megahertz (MHz).
7. To receive stereo broadcasts set the FM mode switch located on
the rear of your CD radio cassette to the 'Stereo' position the Stereo
indicator will light up. If the station being received is weak some hiss
may be audible, to reduce the hiss set the FM mode switch to the
'Mono' position to return to mono operation.
8. Adjust the Deep bass boost switch to the preferred position.
9. To switch off the radio set the Function switch to the 'Tape Off'
position.
7