Filter
Top Products
5
3. Connect the Mains lead to STORM and to the mains and switch ON.
To Connect to Bridged ( Monoblock) Amplifiers:
See Fig. 3
1. Connect to the amplifier using the Neutrik interconnect supplied with
Storm. Connect the RED and YELLOW cores to each of the positive
terminals of the amplifier, ( It does not matter which way around the
red and yellow are connected ). Connect the BLACK core to ground.
(See your amplifier manual for this ground connection)
Bridged Monoblocks
(One channel shown)
Amp 1 Left Speaker
+VE
(Left)
Red
Neutrik Speakon
0V Black Interconnect (Supplied)
To Storm Balanced Input
Yellow
(Right)
Right Speaker
Amp2 +VE
Fig.3
Note:-
Two Storm units are required with Monoblocks. Each Storm will
sense one channel only.
2. Plug the Neutrik plug into the balanced high level input of Storm.
3. Connect the Mains lead to STORM and to the mains and switch ON.
SETTING UP