Filter
Top Products
6
IV. Tuning the Speaker
1. Press the Power/tuning/volume (B) up to turn the speaker ON. The
power/tuning indicator light (A) will illuminate red until the speaker is tuned
to the transmitter and then the light will illuminate green, indicating that
the speaker is tuned properly. You should hear sound coming from the
speaker now.
Note: If the speaker is not tuned or if the transmitter is not connected
properly, the power/tuning indicator light will continue to illuminate red. If
this occurs, please see the troubleshooting section of this manual.
2. Adjust the volume on the speaker as desired.
3. Mono/stereo operation set up:
a) Monaural operation: The monaural mode (MONO) is recommended
when using a single speaker or if using more than one speaker in different
locations.
For monaural operation, set the left/mono/right switch (D) to “MONO” on
each speaker.
b) Stereo operation: You will need an additional AW811 speaker in order to
utilize the stereo option.
For stereo operation, set the left/mono/right switch (D) to “L” on the
speaker located to the left from the listener, and set the other speaker to the
“R” position.
Note: Interference in the form of static and/or distortion can
sometimes be heard. If this occurs, confirm the transmitter/speaker
adjustments and indicators. If the problem persists, refer to the
Troubleshooting section of this manual.
Speaker Front View:
A. Power/tuning indicator light
A
Speaker Side View:
B. Power/tuning/volume control
C. Speaker power input jack
D. Left/mono/right switch
B
D
C