Filter
Top Products
If the existing auto sound component (radio or tape player) has RCA-type
line output jacks:
1. Connect the radio/tape player's line outputs to the equalizer/booster's
LINE INPUT jacks using shielded cables with RCA-type plugs. (Connect
left to left and right to right.)
2. Disconnect the square, in line connectors in the equalizer/booster's
output wiring harness.
3. Insert the equalizer/booster's output wiring plug into the matching
jack on the existing radio/type player (or into the matching jack that
you or a qualified technician added to the existing component).
If the existing auto-sound component (radio or tape player) does not have
RCA-type line output jacks:
1. Be sure that the square, in line connectors in the equalizer/booster's
output wiring harness are securely connected.
2. Insert the equalizer/booster's output wiring plug into the matching
jack on the existing radio/tape player (or into the matching jack that
you or a qualified technician added to the existing component).
Installing The Proper Fuses
If the fuse for your existing auto sound unit is not rated at 3 amps,
replace the fuse in the equalizer/booster's output wiring harness with a
fuse that matches the rating of the existing unit's fuse.
If the existing unit's fuse is rated at 4 amps or higher, replace the fuse
in the equalizer/booster's red power wire with a 15 amp fuse.
Testing The Equalizer/Booster
Before mounting the equalizer/booster in the location you chose earlier,
we suggest that you reconnect the vehicle battery's positive (+) wire and
test your entire auto-sound system. See "Operation" in Faxback Doc.
# 46783.
Mounting The Equalizer/Booster
Attach the equalizer/booster as follows in the location you chose prior to
connecting the wiring. If you used the supplied wiring harnesses, you can
unplug the wires to make mounting more convenient.