Filter
Top Products
12
TROUBLE SHOOTING
Symptom
High-frequency sounds are
emphasized.
The sounds from previous
recordings are still on the tape
with new recordings.
The sound is distorted.
There is too much noise.
Cause
• A tape recorded with Dolby NR is
being played back with DOLBY NR
set to OUT.
• The tape heads are dirty.
• The recording level is too high.
• The original signal was distorted.
• The heads are dirty.
• Poor-quality tape is being used.
• There is a faulty connection.
• The tape heads are dirty.
Remedy
• Set DOLBY NR to the same position as
was used for recording.
• Clean the tape heads.
• Set RECORD LEVEL ATT to IN.
• Replace the original recording source.
• Clean the tape heads.
• Use a better-quality tape.
• Check all connections.
• Clean the tape heads.
PRB1199A.En.10.16.DOC 9/2/99, 9:23 PM12