Filter
Top Products
EN
21
Advanced Sound Control
Fine Setting of the Speakers
This receiver supports a wide range of speakers and
subwoofers. For optimal surround sound enjoyment,
you need to register the speaker selection settings of
your audio system. If you buy this receiver with
accompanied speaker package, then this step has
been done for you.
Also, to make the surround sound more effective and
suit the acoustic conditions in your listening room,
you need to delay the signal from some of the speak-
ers. Such channel delay compensates for center or
surround speakers that are closer to listening position
than the front speakers. You can make use of the
SETUP button to adjust the speakers’ relative loud-
ness.
The TEST TONE button
You can adjust the relative loudness of the individual
speakers by the TEST TONE button.
1. In Surround (Dolby Digital/Pro Logic/DTS) modes,
press TEST TONE briefly. A short noise will be heard
in the speakers one by one. The speaker having the
noise at that moment will be shown in the display.
2. To adjust the volume level of the test tone, turn
up/down the VOLUME knob or press VOL UP/DOWN
key on the remote control.
3. To adjust individual speaker volume level, press the
LEVEL key on the main unit when the short noise is
played on the speaker you want to adjust then turn
the VOLUME knob to modify the output level.
4. Press LEVEL again to save your setting.
5. Repeat step 3 to adjust other speaker volume lev-
els.
Advanced Setting
Factory defaulted Advance setting indication
from VFD
The receiver has defaulted the following distances:
Front speakers
(L/R) 15 ft
Center speaker
(Cch) 15 ft
Rear speaker
(SUR) 10 ft
Speaker Configurations
You can also change the setup of the speakers by
pressing the SETUP button until the display shows
L/R SML or L/R LRG which enables you to set the size
of the front speaker.
Available Selections:
Pressing SETUP button once, while the display is still
showing L/R LRG, you may press the OK button to
toggle among: front, center, surround, subwoofer,
subwoofer phase and speakers’ distance, sleep and
dimmer setup. Set the speaker size or speakers’ dis-
tance by pressing UP/DOWN ARROW button.
R/S
L/S
Rch
Cch
Lch
Front
Left
Rear
Right
Rear
Left
Front
Right
Center
Front Speaker selection Large/ Small
Center Speaker selection Large/ Small/ None
Surround Speaker selection Large/ Small/ None
Subwoofer selection Yes/ No
Subwoofer Phase + / -
Front Speaker distance 3-40 ft
Centre Speaker distance 0-40 ft
Rear Speaker distance 0-40 ft
EQ DIGITAL INPUT
ST / MONO
S
OK
SETUP TEST TONE
MODE
MODE
BASS/TREBLE
VOLUME
LEVEL
NOTE
To adjust the level of all speakers (center and
surround speakers), you must select Pro Logic
mode first by pressing the SURROUND key
BASS/TREBLE LEVEL
VIDEO
V-AUX
L - AUDIO - R