Filter
Top Products
9
Fig 9
Fig 10
Step C: Setting up your TV to use
the ANT3901
1. Access the menu of your TV and make sure the TV is in
ANT/AIR mode and not CABLE/CATV mode. Please refer
to your TV manual for the exact steps to change this option.
2. Access the menu of your TV and run the “Auto Channel
Search” option. Please refer to your TV manual for the
exact steps to change this option.
3. Turn on your DBS receiver and set to ANT, then tune your
TV to your favorite channel.
4. To fine tune local channel reception, rotate the ANT3901
antenna around the perimeter of the dish until you receive
the best possible picture. Tighten the clips so that the antenna
is firmly secured to the satellite dish in that position.
5. The ANT3901 is now ready to receive local programming.
Note: Satellite receiver should be off to view local channels.
ANT3901new 4/29/03 8:37 Page 9