Filter
Top Products
ANT2050X
Omni-Directional
DBS Off-Air Antenna
Direct
Broadcast
Satellite
WARNING!
USE EXTREME CAUTION WHEN INSTALLING AN
OUTDOOR ANTENNA CLOSE TO OVERHEAD WIRES.
IF THE ANTENNA STARTS TO FALL, LET IT GO! IF
ANY PART OF THE ANTENNA MAKES CONTACT
WITH OVERHEAD POWER LINES, TOUCHING THE
ANTENNA, MAST, CABLE OR GUY WIRES CAN CAUSE
ELECTROCUTION AND DEATH. CALL THE POWER
COMPANY TO REMOVE THE ANTENNA. DO NOT
ATTEMPT TO REMOVE IT YOURSELF.
IMPORTANT SAFETY PRECAUTIONS:
Please read and follow these important safety precautions:
• Be sure to select an antenna site well away from any
overhead wires.
• Do not try to guess which overhead wires carry high voltage.
• Always check with the power company whenever
overhead wires are involved.
• If you notice anything making contact with the overhead wires,
call the power company to have the item removed properly.
• Do not run the downlead cable over power wires.
• If there is any doubt of clearing overhead wires, only a
qualified professional should remove an old antenna.
• Never install the antenna outdoors in windy conditions.
• Make sure the antenna downlead cable is connected to
suitable lightning arresters if antenna is not mounted on
the DBS Antenna.
• Make sure the antenna installation is secure.
LIGHTNING PROTECTION:
When ANT2050X is not mounted on the pole of the DBS
antenna, a copper ground wire (not included) should be
installed from the “To TV” F connector on antenna to a
grounding block (not included). This grounding block
should be as close as possible to where the down lead
enters the house.
CAUTION