Filter
Top Products
5. Phase Control: This control changes the phase of the subwoofer. Changing the phase
will change the way the subwoofer and main speakers interact with each other at the
crossover frequency. Varying the phase position may result in more or less mid bass
depending on the phasing between the main speakers and the subwoofer.
6. Line Inputs: Line level input should only be used if no subwoofer crossover is being
utilized through the receivers bass management.
7. LFE In: Line level input is used to connect to most receivers or processors. The “LFE”
output of receiver and may be called “subout”.
8. Fuse Access: This is the power fuse access.
WARNING! In the event the fuse must be replaced, the replacement fuse must
match exactly the original fuse value. If the replacement fuse is not of the same
value, damage to the Subwoofer Amplifier may result.
CAUTION! Before replacing the fuse, disconnect the power cord from the
power receptacle.
9. Power: Power on and off switch.
10. LFE Out: This RCA terminal is for “daisy chaining” to another subwoofer.
7
Subwoofer Amplier Controls and Setup (continued)