Filter
Top Products
5. Use the bracket knobs to attach the speaker to the bracket, being careful to not
tighten the knobs until the desired location is attained; this will allow the speaker
to be angled slightly so the rear binding posts are accessible.
6. Connect one wire to the black terminal and one to the red terminal, paying close
attention to the markings on the wire for proper polarity. Each speaker must be
connected to the amplifier in the same way.
NOTE: Before proceeding, if you are unfamiliar with running speaker wires and
are uncomfortable with this type of installation, please contact a qualified installation
professional.
When all connections have been made and double-checked, turn on your receiver/amplifier
and test for proper operation by walking around the listening area to ensure sound is
coming from all connected speakers. If a speaker is not working correctly, please refer
to the troubleshooting section of this manual. If working properly insert knob covers to
complete installation.
4
Installation (continued)
Operation
An amplifier with an output power rating of 25-100 watts per channel is recommended.
This will help to protect the speaker from being under or over driven, which may cause
permanent damage.
When listening to the speakers outdoors, keep in mind that there are very few walls
to reinforce the sound. Therefore, be careful not to drive the speakers beyond their
capabilities when trying to obtain a desired volume level. You will be able to determine
audibly when the speaker is being overdriven by the “break up” or distorted sound that
will be coming from the speaker.