Filter
Top Products
Installation (continued)
3
NOTE: The binding posts will accept a maximum wire gauge of 14 AWG and a
minimum wire gauge of 18 AWG. Please refer to the NEC (National Electrical Code)
for further information regarding the permissible wire size.
2. Install speaker into the ceiling.
NOTE: Carefully tuck the speaker wires up
into the ceiling so they
do not get pinched.
3. Set the three switches located on the
face of the speaker to the proper setting
according to the installation, see the
guidelines below:
A: The A-605/70 can be used in a 70/100
volt system or as a standard 8 Ohm
in-ceiling speaker. To properly set the
speaker to a 70/100 volt system or as a
standard 8 Ohm operation slide the switch to the proper position on the face
of the speaker.
NOTE: In 70/100 volt operation, be sure to appropriately set the selector
according to the power output of the amplifier being used and the number
of speakers being installed. In 8 Ohm operation, be sure to set the selector
to the 8 Ohm setting.
B: Slide the switch into the proper position in order to choose from 2, 4, 8 and
16 Watt taps in 70/100 volt operation.
C: To customize the sound of the tweeter slide the switch located on the front
baffle of the speaker to either: +3dB, 0dB, -3dB.
A: Switch for 70/100 Volt
or 8 Ohms Operation.
B: Switch for Watt Taps in
70/100 Volt Operation.
C: Switch for Tweeter
Adjustment.