Radio Shack PRO-LS200 Speaker User Manual


 
3
N
NN
No
oo
ot
tt
te
ee
e:
: :
: For the best overall performance,
connect your speaker so it is in phase
positive to positive (+ to +) and negative
to negative (– to –).
1. With the speaker in its approximate
location, measure the distance to the
amplifier and route the wire from the
speaker to the amplifier.
2. Separate the wire conductors for a
length of about 2 inches, then
remove about 1/2 inch of insulation
from the wire’s ends using a wire
stripper.
3. Press the speaker’s black negative (–)
terminal tab and insert one of the
bare wire ends into the opening.
Then release the tab.
4. Press the speaker’s red positive (+)
terminal tab and insert the other bare
wire end into the opening. Then
release the tab.
5. Connect the other end of the wire
from the speaker’s black terminal to
the amplifier’s negative center (–)
terminal, and the wire from the
speaker’s red terminal to
theamplifier’s positive (+) center
terminal.
C
CC
Ca
aa
ar
rr
re
ee
e
Keep the PRO-LS200 dry; if it gets wet,
wipe it dry immediately. Use and store
the speaker only in normal temperature
environments. Handle the PRO-LS200
carefully; do not drop it. Keep the PRO-
LS200 away from dust and dirt, and wipe
it with a damp cloth occasionally to keep
it looking new. Modifying or tampering
with the PRO-LS200’s internal
components can cause a malfunction and
might invalidate its warranty
C
CC
Ca
aa
au
uu
ut
tt
ti
ii
io
oo
on
nn
n:
: :
: You might permanently damage
your speakers by cleaning them with a
vacuum cleaner. Use a feather duster or a
soft loose cloth instead.
This speaker has been manufactured to
the specifications of RadioShack and is
covered by a limited warranty from
RadioShack. If your receiver is not
operating as it should, take it to your local
RadioShack store or call 1-800-THE-
SHACK for assistance.
1
/
2
''
Black Terminal
(–)
Red Terminal
(+)