Filter
Top Products
10
Specifications
CLEANING THE TAPE-HANDLING PARTS
Dirt, dust, or particles of the tape's coating can accumulate on the tape heads and
other parts that the tape touches. This can greatly reduce the performance of the cas-
sette player. After every 20 hours of tape player operation, follow these steps to clean
the tape-handling parts or use a RadioShack cassette deck cleaning kit.
1. Remove the batteries and disconnect any other power source.
2. Open the cassette compartment door and press
PLAY
to expose the tape-
handling parts.
3. Use a cotton swab dipped in denatured alcohol or tape head cleaning solution to
clean the tape guides, record/play head, pinch roller, and capstan.
4. When you finish cleaning, press
STOP/EJECT
and close the cassette compart-
ment door. Then reconnect power.
ˆ
Specifications
CASSETTE PLAYER
Track System ................................................................................................. 2-Track Monaural
Tape Speed ................................................................................................................ 4.75 cm/s
Recording System ......................................................................................................... AC Bias
Frequency Response (@
±
6 dB) ...................................................................... 125 Hz–6.3 kHz
Signal-to-Noise Ratio ....................................................................................................... 35 dB
Wow and Flutter (WRMS) ............................................................................................ < 0.25%
Tape Guides
Capstan
Pinch
Roller
Record/Play Head
14-1128.fm Page 10 Thursday, April 6, 2000 3:24 PM