Filter
Top Products
Page. 4
P / N : 570-F10602-03
WIRE CONNECTION RESET FUNCTION
P / N : 570-F10602-03
UNIT REMOVAL
1. Remove Front Control Panel.
2. Slightly insert the key into the slot and
gently to release.
3. Separate the sleeve from the unit. Keep
release key in a safe place as you may
need for future removal of unit.
INSTALLATION
REMOTE CONTROL
The RESET button is located at the back of the
panel. It is recessed in order to prevent accidental
engagement, and can be activated with the tip of a
ball-point pen or any similar pointed object. This
reset circuitry is provided in order to protect the
unit's microprocessor, and should only be activated
under the following conditions :
a) Initial installation after all wiring is completed.
b) Abnormal operation is encountered such as
numerical indication on display is erratic.
c) Whenever the reset button is activated, all preset
memory content will be erased and must be
reprogrammed.
CAUTION : Do not connect the speaker wires to chassis
or car body. Each speaker wire cannot be soldered
together with other wires. Otherwise, the unit will be
damaged and no sound will come out anymore.
CAUTION : DO NOT PLACE THE UNIT OVER THE
MAXIMUM INSTALLATION ANGLE OF 30°.
OTHERWISE, THE UNIT MAY NOT WORK
PROPERLY.
WARNING!!
Due to protection of CD Mechanism, two small screws on the top
of the unit must be released before operate the unit. Otherwise, the
CD Mechanism can not be working properly.