Filter
Top Products
LOCATION AND FUNCTION OF CONTROLS
1. SEL( AUDIO MODE SELECT)/VOLUME +/- BUTTONS
Press SEL button to change the mode in the sequence of
VOL BAS TRE BAL FAD
1). The volume level can be adjusted at any time by pressing the audio level+ or
- button as select mode has been initially defaulted at volume mode.
2). The volume level is also obtained by stepping through the SEL button until
the character VOL is displayed and then press + or - button to adjust the
sound level.
3). Press and hold the + or - button to adjust the sound level.
BASS CONTROL
1). Press the SEL button to select the bass mode until BAS appears on the display.
2). Press + or - to adjust the bass effect.
3 8
SPECIFICATION
GENERAL
Power requirement..............................................................................................DC 13.8V.
Chassis dimensions.......................................................................178[W] X 50[H] X 150[D].
FM SECTION
Frequency range.....................................................................87.5MHz -108.0MHz(EUROPE).
Frequency range...........................................................................87.5MHz -107.9MHz(USA).
Usable sensitivity.........................................................................................................3uV.
I.F Frequency........................................................................................................10.7MHz.
AM(MW) SECTION
Frequency range........................................................................522KHz - 1620KHz(EUROPE).
Frequency range............................................................................. 530KHz - 1710KHz(USA).
LINE - OUT [OPTION]
Output...............................................................................1000mV @ FM 10% THD POWER.
Impedance............................................................................................................600 ohm.
CD PLAYER
System........................................................................................compact disc audio system.
Usable disc......................................................................................................compact disc.
Signal format.............................................................................sampling frequency 44.1KHz.
No of quantization bits 1bit.
Signal to noise radio................................................................70dB [1KHz] [IEC - A net work].
Number of channels..............................................................................................2 STEREO.
Current consumption..............................................................................................7A MAX.
Power output.........................................................................................................40W X 4
Frequency characteristics...............................................................................5-40Hz < 5dB
10K-20KHz < 5dB.
TREBLE CONTROL
1). Press the SEL button to select the treble mode until TRE appears on the display.
2). Press + or - to adjust the treble effect.
1 2 3
4 5 6 7
8
9
10 11
12
13 14 15
This radio is set to USA frequency by factory, if European
frequency is required please flip the frequency step switch on
the side of the unit.
After the switchover of the frequency switch, the frequency convert
function will not be valid until the RESET button has been pressed.
USA EUROPE
IMPORTANT:
CLK
DSP
SEL
LUD
OPEN
+
-
LO
1
TOP
2
RPT
3
INT
4
RDM
5
6
MU
AP
BD
power
UP
DN
CDP
FLIP DOWN DETACHABLE CD PLAYER
COMPACT
DIGITAL AUDIO
FLAT CLASS ROCK POP
TRACK
LOC LOUD MUTE DISC
CH
RPT RDM INT