Filter
Top Products
RadioShack Corporation
Fort Worth, Texas 76102
40-4093
03A02
Printed in China
3. Using a wire stripper, remove about
1
/
4
inch of insulation from each wire. Then
twist the ends of each wire.
4. Connect the marked wire to a red
speaker terminal by pressing the release
tab, inserting the wire into the hole, and
then releasing the tab. Repeat this
procedure to connect the unmarked wire
to the black terminal.
5. Connect the marked wire coming from
the speaker to the left channel of the
receiver's positive (+) terminal. Then
connect the unmarked wire to the left
channel of the amplifier's negative (–)
terminal.
/1706+0)"6*'"52'#-'4
1. Remove the grille to expose the
mounting screws.
2. Be sure the mounting tabs are turned in,
allowing the speaker to fit into the hole.
Then insert the speaker into the
mounting hole.
3. Use the four screws to tighten the
mounting tabs to the wall or ceiling. Be
careful not to overtighten the screws.
4. Replace the grille.
To remove the speaker from the wall or
ceiling, loosen the screws only far enough to
remove the speaker. This will prevent loss of
the mounting tabs.
52'%+(+%#6+105
Resonance Frequency ................................................................................................................60 Hz ±20%
Frequency Response ................................................................................................... 35 Hz through 22 kHz
Power Rating................................................................................................... 40 Watts RMS, 80 Watts Max.
Impedance (nominal)...........................................................................................................................8 Ohms
Sensitivity .....................................................................................................................................85 dB ±3 dB
Voice Coil ................................................................................................................................... 1 in. (25 mm)
Voice Coil (Tweeter) ................................................................................................................. 1 in. (25 mm)
Magnet Size (Woofer)..............................................................................................................................11 oz
The plastic enclosure for this speaker meets UL 94 requirements for flammability.
Specifications are typical; individual units may vary. Specifications are subject to change or improvement
without notice.
Mounting
Tabs
Limited Two-Year Warranty
This product is warranted by RadioShack against
manufacturing defects in material and workmanship
under normal use for two (2) years from the date of
purchase from RadioShack company- owned stores
and authorized RadioShack franchisees and dealers.
EXCEPT AS PROVIDED HEREIN, RadioShack
MAKES NO EXPRESS WARRANTIES AND ANY
IMPLIED WARRANTIES, INCLUDING THOSE OF
MERCHANTABILITY AND FITNESS FOR A PAR-
TICULAR PURPOSE, ARE LIMITED IN DURATION
TO THE DURATION OF THE WRITTEN LIMITED
WARRANTIES CONTAINED HEREIN. EXCEPT AS
PROVIDED HEREIN, RadioShack SHALL HAVE NO
LIABILITY OR RESPONSIBILITY TO CUSTOMER
OR ANY OTHER PERSON OR ENTITY WITH RE-
SPECT TO ANY LIABILITY, LOSS OR DAMAGE
CAUSED DIRECTLY OR INDIRECTLY BY USE OR
PERFORMANCE OF THE PRODUCT OR ARISING
OUT OF ANY BREACH OF THIS WARRANTY, IN-
CLUDING, BUT NOT LIMITED TO, ANY DAMAGES
RESULTING FROM INCONVENIENCE, LOSS OF
TIME, DATA, PROPERTY, REVENUE, OR PROFIT
OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES, EVEN IF Ra-
dioShack HAS BEEN ADVISED OF THE POSSIBIL-
ITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an
implied warranty lasts or the exclusion or limitation of
incidental or consequential damages, so the above
limitations or exclusions may not apply to you.
In the event of a product defect during the warranty
period, take the product and the RadioShack sales
receipt as proof of purchase date to any RadioShack
store. RadioShack will, at its option, unless otherwise
provided by law: (a) correct the defect by product re-
pair without charge for parts and labor; (b) replace
the product with one of the same or similar design; or
(c) refund the purchase price. All replaced parts and
products, and products on which a refund is made,
become the property of RadioShack. New or recondi-
tioned parts and products may be used in the perfor-
mance of warranty service. Repaired or replaced
parts and products are warranted for the remainder
of the original warranty period. You will be charged
for repair or replacement of the product made after
the expiration of the warranty period.
This warranty does not cover: (a) damage or failure
caused by or attributable to acts of God, abuse, acci-
dent, misuse, improper or abnormal usage, failure to
follow instructions, improper installation or mainte-
nance, alteration, lightning or other incidence of ex-
cess voltage or current; (b) any repairs other than
those provided by a RadioShack Authorized Service
Facility; (c) consumables such as fuses or batteries;
(d) cosmetic damage; (e) transportation, shipping or
insurance costs; or (f) costs of product removal, in-
stallation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state.
RadioShack Customer Relations, 200 Taylor Street,
6th Floor, Fort Worth, TX 76102
12/99