Filter
Top Products
12
Basic Operation
2. Snap the adapter into the docking station.
3. Plug your iPod / iPhone into the adapter.
Playing Tracks
1. Dock your iPod / iPhone.
2. Press POWER to turn on the soundbar.
3. Press FUNCTION to select iPod mode. IPOD
displays.
4. Press
;
to start and pause iPod / iPhone playback.
Press or
to skip to the previous track or to the next track.
Press and hold or
to search backwards or forwards in the current track.
Press REPEAT/ST to select repeat the current track, repeat album or playlist or repeat
off.
Press SHUFFLE to play tracks in an album randomly in your iPod/iPhone.
Press MENU to access the docked iPod menu.
Press or to navigate iPod / iPhone menus.
n Note: Your iPod / iPhone must be updated with the latest firmware from Apple in order
for it to work properly with your sound bar.
Audio Settings
3D Sound
Press EFFECTS to turn 3D sound on and off.
Adjusting Bass and Treble
1. Press TONE/DIMMER on the remote control
until the display shows BASS or TREB.
2. Press VOL + or VOL – to adjust to the desired
level.
Display Brightness
1. Press TONE/DIMMER on the remote control
until the display shows DIMMER level.
2. Press VOL + or VOL – to adjust to the display brightness to the desired level.
3D ON
BASS 00
dB
DIMMER2
Select Source
To play devices connected to your soundbar, you must select the correct input source.
1. Press FUNCTION repeatedly to select:
IN1 or IN2 to play devices connected to
Audio Inputs.
AUX to play device connected to the line
input jack.
Additional Information
Troubleshooting
Problem Possible Solution
No sound Make sure the power cord is plugged in.
The batteries in the remote control may be dead. Replace the
batteries and try again.
The power outlet may be faulty. Plug in another device. If it
does not work, have an electrician inspect the outlet.
Check all wire connections. See pages 8-9.
Remote control does not
work.
Replace batteries in the remote control.
Be sure batteries are installed with correct polarity.
Remove any obstacles between the remote control and TV.
Poor FM reception Make sure FM antenna is plugged in.
Specifications
Output Power/Ch (@ 10% THD) ............................... 12.5W x 2 + 25 W (Total 50W RMS/ 100W Peak)
Freq. Response ...............................................................................................................50Hz ~ 20KHz
Operation Power .......................................................................... 100V~240V AC 50/60Hz.DC:15V 4A
Weight .........................................................................................................................155.2 oz (4400g)
Dimensions (H × W × D) ....................................................4.9 × 31.2 × 5.3 in (12.5 × 79.4 × 13.4 cm)
Specifications are subject to change and improvement without notice. Actual product may vary from the
images found in this document.
IPOD