Radio Shack 40-289 Speaker User Manual


 
5
5
5. Connect the wire from the red speaker terminal
to the amplifier’s positive (+) terminal, then
connect the wire from the black speaker terminal
to the amplifier’s negative (–) terminal.
n Notes:
Avoid routing the speaker wire near electrical wires.
Do not nail, staple, or otherwise puncture the
speaker wire.
Before connecting your speaker to an amplifier,
make sure the amplifier and all associated
equipment is turned off.
Make sure the impedance of the amplifier matches
with the speaker.
3 Mounting the Speaker
1. Remove the grille to expose
the mounting screws.
2. Be sure the mounting tabs are
turned in, allowing the speaker
to fit into the hole. Then insert
the speaker into the mounting
hole.
3. Use the supplied screws to
tighten the mounting tabs to
the wall or ceiling. Be careful
not to overtighten.
4. Replace the grille.
Mounting tabs