Filter
Top Products
20-125
01A07
Printed in China
Whenever the radio is turned on, the last tuned
station will be played.
There are four ways to tune to a radio station:
Manual tuning — Repeatedly press HOUR + or MIN
- to tune up or down.
Automatic tuning — Press and hold HOUR + or MIN
- for more than one second and then release. The
radio searches for a radio program automatically and
stops when a strong signal is received.
Memory tuning — Press the number buttons to
select a preset station directly.
Direct entry to stations — Use the number buttons
to enter the frequency of your station.
presetting radio stations
Store your favorite radio stations as presets in the
memory. You can store up to 10 stations for each
band.
1. Turn on your radio and select a band.
2. Press or hold HOUR + or MIN - to search for a
radio station.
3. Press MEM/TIME to enter the preset mode.
4. As MEMO ashes on the display, press a numberpress a number
from 0 - 9 to select a channel number. CH and the
number appears on the display.
5. Press MEM/TIME to store.store.
6. Repeat steps 2 - 5 to store other stations.
• After you enter the preset mode, complete
each step within 5 seconds, otherwise the
radio exits the presetting mode.
• A newly stored preset station can overwrite a
former preset.
direct entry to stations
1. Turn on your radio and select a band.
2. Press ENTER.
3. Use the number buttons to enter a valid
frequency, and press ENTER.
• For direct entry, complete each step within 10
seconds, otherwise the radio exits the mode
automatically.
• If an invalid frequency is entered, Err ashes.
• Disregard the decimal point when entering
the frequency. If you want to enter 3.20 MHz
of a SW band, press 0, 3, 2, 0.
using your radio
This product is warranted by RadioShack against manufacturing defects in
material and workmanship under normal use for ninety (90) days from the
date of purchase from RadioShack company-owned stores and authorized
RadioShack franchisees and dealers. For complete warranty details and
exclusions, check with your local RadioShack store.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102 04/04
limited 90-day warranty
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult your local RadioShack store or an experienced
radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires
that you stop using your radio. Changes or modications not
expressly approved by RadioShack may cause interference
and void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.
RF emissions information
Frequency Range.......................FM: 88 ~ 108 MHzFM: 88 ~ 108 MHz
....................................................AM: 530 ~ 1710 kHzAM: 530 ~ 1710 kHz
....................................................SW: 2.3 ~ 26.1 MHz
Specications are subject to change and
improvement without notice. Actual product may
vary from the images found in this document.
specications
©2006. RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
To set clock time, complete each step
within 5 seconds, otherwise the radio exits
the clock setting mode automatically.
To view the time while listening to the radio,
press and hold DUAL TIME for 3 seconds. The
time displays for 5 seconds.
1. Turn off the radio. The clock time shows.
2. Press MEM/TIME to select a clock time.
3. As the clock time ashes on the display, press or
hold HOUR + or MIN - to increase the hour or
minute digits within 5 seconds or the radio exits
time setting mode.
4. Press MEM/TIME again or wait for 5 seconds to
save and exit.
5. (Optional) To set an alternate time, press DUAL
TIME. TIME2 displays in the upper left of the
screen. Repeat steps 2 - 4 to set the alternate
time.
setting the clock time
Notes
Notes
Notes
setting the alarm time
1. Press ALARM.
2. As the alarm time ashes, press or hold HOUR +
or MIN - to adjust the hour or minute.
3. When the desired alarm time appears, wait until
the display stops ashing to save and exit.
setting the alarm mode
1. Press ALARM once or twice. Alarm time with M
(buzzer) or + (radio) flashes.
2. When your desired alarm mode appears, wait
until the display stops flashing to confirm. Clock
time and the alarm mode icon appears.
To cancel the alarm, press ALARM three times until
the alarm icon disappears.
When the alarm sounds, press any key to stop it
for 24 hours. Press SNOOZE to mute the alarm for
about 9 minutes.
To ensure the alarm sounds at the desired
time, make sure the correct clock time
displays.
setting the alarm
Note
You can set a timer to beep later (1 minute to 99
minutes).
1. Press TIMER (radio can be on or off).
2. When 00 appears, press TIMER or MIN - to set
the timer.
3. When the desired settings appears, wait for 5
seconds until the last display appears.
TIMER appears when the timer is activated. To view
the remaining time, press TIMER once.
To cancel the timer, set the timer to 00.
To stop the beeping, press any key.
setting the timer
You can set your radio to play for a certain period of
time (10 to 90 minutes) and turn off automatically.
1. Press SLEEP to turn on your radio if not already
switched on.
2. When 10 and SLEEP appear, press SLEEP
repeatedly to select the sleep timer from 10 to 90
minutes.
SLEEP appears when the sleep timer is activated.
Press SLEEP during the sleep timer to cancel the
sleep timer function. SLEEP disappears.
setting the SLEEP timer
• Dispose of old batteries promptly and properly.
• Do not burn or bury batteries.
• Use only fresh batteries of the required size and
recommended type.
• Do not mix batteries of different sizes or chemistries.
• If you do not plan to use your radio for a week
or more, remove the batteries. Batteries can leak
chemicals that can damage electronic parts.
• When ashes on the display, replace the
batteries.
• Automatic tuning may not work properly if battery
power is low. If this happens, replace the batteries.
battery notes
20-125.indd 2 1/08/2007 11:16:17