Please read this user’s guide before
installing, setting up and using your radio.
www.radioshack.com
Thank you for purchasing your AM/FM/SW with Travel Alarm
from RadioShack. You can store two clock times and up to 30
preset stations.
Radio User’s Guide
what’s included
20-125
AM/FM/SW with Travel Alarm
SNOOZE
Press to mute the alarm
for about 9 minutes.
LOCK
Slide up to lock all the buttons.
appears.
LIGHT
Press and hold to turn
on the backlight.
FM/AM/SW
Slide to select a
band.
SW (shortwave) BAND
When listening to SW, press once or
more to fast tune SW frequencies.
HOUR + – Press or hold to tune
radio frequencies or adjust the
hour digit.
MIN - –– Press or hold to tune
radio frequencies or adjust the
minute digit.
ENTER –– See “direct entry to
stations”.
TIMER –– See “setting the timer”.
DX/LOC SENS
(for FM and SW)
Select for best reception of
distant or local stations. Set
to LOC to receive strong local
signals, or set to DX to improve
reception of a weak station.
installing batteries
Slide to remove the battery compartment cover and insert three AA
alkaline batteries matching the polarity symbols (+ and -) marked inside.
To avoid losing memory and alarm settings, turn off the radio before
replacing the batteries and replace the batteries within 30 seconds.
using AC power supply (DC 6V )
Connect one end of an optional AC adapter to DC 6V jack of
your radio and the other end to an standard AC wall outlet.
Note
POWER
ON/OFF
Press to
turn on/off
the radio.
ALARM
Press to enter
alarm setting
mode (see
“setting the
alarm”).
SLEEP
Press to select a preset period to
automatically turn off the radio (see
“setting the sleep timer”).
MEM/TIME
Press to enter radio preset
mode/clock time setting
mode. (see “presetting
radio stations” and
“setting the clock time”).
DUAL TIME
Press to toggle
between the two
clock times. Hold for 5
seconds to view time
when radio is on.
ANTENNA (for FM and SW)
FM: Fully extend the antenna,
and rotate for best reception.
SW: Position the antenna
vertically for best reception.
AM: This uses a built-in
ferrite rod antenna. Position
your radio for best reception.
Stand
Pull out and place radio
on a level surface.
CAUTION: You must use a power source that supplies DC 6V
and delivers at least 300 mA. Its center tip must be set to positive
and its plug must t the radio’s DC 6V jack. Using an
adapter that does not meet these specications could damage the
radio or the adapter.
•Always connect the AC adapter to the radio before you connect it to AC
power. When you nish, disconnect the adapter from AC power before you
disconnect it from the radio.
• The correct orientation for this power unit is in a vertical or oor mount
position.
!
VOL MAX-MIN
Turn to adjust the
volume.
HIGH/LOW TONE
Switch to HIGH for
normal sound and
to LOW to reduce
high frequencies.
*
Connect 3.5mm
headphones (not
supplied) for
private listening.
20-125.indd 1 1/08/2007 11:16:16