Filter
Top Products
2
+/2146#06"5#('6;"
+05647%6+105
1. All the safety and operating instructions
should be read before the product is
operated.
2. The safety and operating instructions
should be retained for future reference.
3. All warnings on the appliance and in the
operating instructions should be
adhered to.
4. All operating and use instructions
should be followed.
5. Do not use this appliance near water.
6. Clean only with dry cloth.
7. Do not block any ventilation opening.
Install in accordance with the
manufacturer’s instruction.
8. Do not install near any heat sources
such as radiators, heat registers,
stoves, or other appliances (including
amplifiers) that produce heat.
9. Do not defeat the safety purpose of the
polarized or grounding-type plug. A
polarized type plug has two blades with
one wider than the other. A grounding
type plug has two blades and a third
grounding prong. The wide blade or the
third prong is provided for your safety. If
the provided plug does not fit into your
outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being
walked on or pinched particularly at
plugs, convenience receptacles, and
the point where they exit from the
apparatus.
11. Unplug this apparatus during lighting
storms or when unused for long periods
of time.
12. Refer all servicing to qualified service
personal. Servicing is required when
the apparatus has been damaged in
any way, such as power-supply cord or
plug is damaged, liquid has been spilled
or objects have fallen into the
apparatus, the apparatus has been
exposed to rain or moisture, does not
operate normally, or as been dropped.
13. This appliance should not be exposed
to dripping or splashing water and
objects filled with liquids such as vases
should not be placed on the apparatus.
24'2#4#6+10
%100'%6+0)"6*'"52'#-'45
There are no differences between the two
speakers. Both speakers can be connected
as
L
(left) or
R
(right) speaker.
Connect the lead wires of the left and right
speakers to the speaker terminals at the
backside of the main unit.
.
..
.
+056#..+0)"$#66'4+'5"+0"6*'"
4
'/16'"%106 41.
The remote control requires two AA
batteries (not supplied) for power. For the
best performance and longest life, we
recommend RadioShack alkaline
batteries.
.
..
.
1. Press and slide the battery
compartment cover in the direction of
the arrow to remove it.
2. Place the batteries in the compartment
as indicated by the polarity symbols
marked inside.
3. Replace the cover.
The maximum operational distance between
the remote control and the sensor should be
16 feet (5 meters) approximately. If the
remote control only operates at a much
shorter distance, replace the batteries.
Rý
%100'%6+0)"6*'"5;56'/"61"
#%"2
19'4
Insert the AC power plug into a standard AC
outlet. The red power LED (Light Emitting
Diode) lights. If the clock has never been set
the LCD (Liquid Crystal Display) shows
&0&&
&0&&&0&&
&0&&
.
Press the
POWER
. The red power LED turns
off. At the same time, the blue top LED and
the blue LCD backlight turns on.
The unit was designed so that the CD mode
plays when the stereo is powered up for the
first time. If it is not the first time to power on,
the stereo will be in the last listening mode
used.
• If the last listening mode was CD, when
the unit is powered on, the display
shows
9:
9:9:
9:
, total numbers of tracks and
total times (if there is a CD disc loaded)
or
deýZ_iY
deýZ_iYdeýZ_iY
deýZ_iY
(if no disc is loaded).
• If the last listening mode was tuner,
when the unit is turned on,
JKD;H
JKD;HJKD;H
JKD;H
and
the last played station’s frequency are
displayed. Play begins at once.
• If the last listening mode was tape,
when the unit is turned on,
J7F;
J7F;J7F;
J7F;
and the
time of day are displayed.
56#0&$;"/1&'
Press
POWER
while power is on. The unit
goes into standby mode. The red LED lights
while the top LED and the LCD backlight
turns off at the same time. In standby mode,
the LCD display still shows the clock.
70+6"(#%'
Once the CD/Tuner or Tape is selected by
pressing
FUNCTION
, its corresponding unit
face automatically rotates to the front.
±
.
"%#76+10"
.
Connecting the Speakers
Do not confuse the polarity of lead wires of
speakers. The solid red wire should be
connected to the red terminal.
Installing Batteries in the Remote Control
• Use only fresh batteries of the required size
and recommended type.
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
R
"9#40+0)
ý
R
"
Dispose of old batteries promptly and properly.
Do not burn or bury them.
±
"016'"
±
"
ROTATE is designed to turn the tape side to
the front for the convenience of loading or
unloading tapes while recording from the CD
player or a radio program. If the unit face does
not turn to match the corresponding play mode
when FUNCTION is pressed, press ROTATE
to change the unit face.