Filter
Top Products
2
• If you selected door locations,
you might need to punch a
small hole in the door edge
(near the door hinges) to route
the wires into the door. Leave
enough slack wire to open the
door all the way.
5. Securely connect the positive (+)
and negative (–) stripped speaker
wire ends to the corresponding
speaker terminals.
Cautions:
• Improper phasing can cause
poor bass response. To ensure
proper phasing, you need to
match your autosound sys-
tem’s positive (+) and negative
(–) speaker wires to the corre-
sponding positive (+) and nega-
tive (–) speaker terminals.
• Do not connect any of your
speaker terminals to chassis
ground. Use all four autosound
wires to connect your speakers
to your vehicle’s autosound sys-
tem.
If you have a two-speaker sys-
tem:
If you have a four-speaker sys-
tem (front and rear):
6. Remove the grille from each
speaker’s mounting bracket to
expose the mounting holes.
7. Place the mounting bracket on the
speaker.
(illus - show the speaker
wires properly wrapped
around the speaker’s ter-
minals.)
(illus showing wiring
diagram for connec-
tion to two speakers
with proper polarity)
(illus showing wiring
diagram for connec-
tion to four speakers
with proper polarity)
(illus – show how
the bracket fits on
the speaker.)
12-1738.fm Page 2 Friday, January 7, 2000 9:07 AM