QUAD Speaker Speaker User Manual


 
HOME THEATRE LOUDSPEAKER CONNECTIONS
SETTING LOUDSPEAKER SIZES IN HOME THEATRE SYSTEMS
Many digital AV Processors require you to specify the size of speakers in all channels.
These are usually ‘Large’ or ‘Small’.
Always choose 'Small' for the Surround channels and Centre channel whether you are using
a subwoofer or not.
If you are not using a subwoofer: Set the Front Speakers to ‘Large’. Set the ‘Subwoofer’
option on the processor to ‘Off’ or ‘No’. The Front channels will receive all the system bass.
If you are using a subwoofer: When set to ‘Small’ all the system bass will go into the
subwoofer. If you choose ‘Large’ the Front channel bass will be sent to the Front speakers.
Bookshelf speakers should be set to ‘Small’, large floor standing units may be set to ‘Large’.
Refer to your A/V processor manual for details on setting up your Home Theatre system.
GETTING THE BEST FROM YOUR LOUDSPEAKERS
Phase
If the sound lacks definition or the bass is indistinct, this could be because you have
inadvertently mis-connected your loudspeakers. Please check the wiring to all the
loudspeakers carefully, especially if they are bi-wired.
Ancillary Equipment
QUAD loudspeakers are compatible with the great majority of audio-visual and high fidelity
equipment - but a loudspeaker is only as good as the signal it gets. Your amplifier should have
ample reserves of power - a low powered amplifier can run out of steam and the resulting
distortion is unpleasant to listen to and could damage your speakers. A larger amplifier will
usually sound better and enhance the reliability and performance of your loudspeakers.
Running In
Loudspeakers are electro-mechanical and, like all mechanical systems, they need a 'running
in' period. For the first 50 hours or so exercise care and play your system at reasonable
volume levels. After running in, you will notice a significant sonic improvement.
Care and Maintenance
Little maintenance is required. The cabinets can be occasionally wiped with a damp (not wet)
cloth. Spray polish, if used, should be applied sparingly - spray the polish onto a cloth and
then apply it to the speaker. NEVER spray the grille cloth or the speaker drive units. To clean
the grilles, remove them first before gently brushing with a soft brush. Never use solvent
cleaners, minor stains are best removed with soap and lukewarm water.
INTRODUCTION
The Quad L-ite Centre is a dedicated centre channel loudspeaker, voiced to blend
seamlessly with the other loudspeakers in the L-ite Series, though it can be used with any
high performance loudspeakers.
A secondary use could be as low level background sound reinforcement
applications where clarity and precision are a requirement.
When partnered with either a pair of Quad L Series loudspeakers as the Front channels, and
the Quad L-ite Satellites as Rear Effects channels, a Home Theatre system of outstanding
performance can be built up.
Please read the following notes carefully. They will help you to install your
loudspeaker correctly and safely.
! Switch off the amplifier and all sources before making connections to your sound
system. When you switch on the system or change sources, set the volume control to
minimum and turn up the level gradually.
! The position of your Volume Control is NOT a reliable guide as to the maximum
capabilities of your sound system. Playing the system with extreme settings of volume
and/or tone controls may damage the amplifier and loudspeaker and your hearing.
! Do not connect loudspeaker terminals to the mains supply.
! Ensure that your loudspeakers are correctly wired and are in phase.
! Do not subject your loudspeakers to excessive cold, heat or sunlight.
! WARNING: To reduce the risk of fire or electrical shock do not expose this product to
rain or moisture. The product must not be exposed to dripping and splashing and no
object filled with liquids - such as a vase of flowers - should be placed on the product.
! No naked flame sources - such as candles - must be placed on the product.
! Do not place heavy objects on top of loudspeaker cabinets. If you play the loudspeakers
with the grilles removed be careful to protect the drive units from children and pets.
! Do not use makeshift stands. Always fit a manufacturer's approved stand using the
instructions and the fixings provided. Your dealer will advise you.
! Do not attempt to dismantle the loudspeaker. There are no user serviceable parts inside
and you will invalidate the warranty.
! The Centre Channel loudspeaker is screened and may safely be operated close to a TV set.
1
L-ite Centre
4
HF
LF
QUAD
ELECTROACOUSTICS
LTD.
and
Engineered by
Designed
HF
LF
QUAD
ELECTROACOUSTICS
LTD.
and
Engineered by
Designed
HF
LF
QUAD
ELECTROACOUSTICS
LTD.
and
Engineered by
Designed
Centre
Left
Surround
Front Right
Rear Right
Front Left
Rear Left
Centre
A/V
Amplifier
Front Right
HF
QUAD
ELECTROACOUSTICS
LTD.
and
Engineered by
Designed
LF
HF
LF
QUAD
ELECTROACOUSTICS
LTD.
and
Engineered by
Designed
LINE LEVEL
LEFT
INPUT
OUTPUT
RIGHT
QUAD L-ite Subwoofer
LINE LEVEL
Subwoofer
Front Left
Right
Surround