Filter
Top Products
1675 MacArthur Boulevard
• Costa Mesa, CA 92626 • Ph: 800/854-4079 or 714/957-7100 • Fax: 714/754-6174 •
www.qscaudio.com
PLX Spec Sheet 10/10/03
PLX1602
PLX SPECIFICATIONS
200W
8 ohms 20 Hz–20 kHz 0.03% THD
4 ohms 20 Hz–20 kHz 0.05% THD
2 ohms 1 kHz 1% THD
Noise (20 Hz–20 kHz)
Input Sensitivity @ 8 ohms
Input Sensitivity @ 4 ohms
325W
600W 800W 1200W
1500W 1700W
500W 700W 900W 1100W
300W 425W
550W
700W
PLX2402 PLX3002
Stereo Mode (both channels driven)
Bridge Mono Mode
4 ohms 1 kHz 1% THD
16 ohms 20 Hz–20 kHz 0.1% THD
8 ohms 20 Hz–20 kHz 0.1% THD
400W
700W 1100W 1500W 2000W 2200W
1200W 1600W 2400W 3000W 3400W
600W 850W 1100W 1400W
PLX3402
< -106 dB
< -107 dB < -108 dB
< -107 dB
< -107 dB
1.0 Vrms 1.2 Vrms 1.5 Vrms 1.7 Vrms 1.9 Vrms
0.9 Vrms 1.1 Vrms 1.3 Vrms 1.5 Vrms 1.7 Vrms
Output Circuitry
AB AB 2-Step Class H 2-Step Class H 2-Step Class H
Power Requirements
(
1/8 power pink noise @ 4Ω)
6 A 10 A 8 A 10 A 12 A
PLX1202
Distortion (SMPTE-IM)
Distortion (typical)
Frequency Response
Damping Factor
Input Impedance
Input Clipping
Cooling
Connectors (each channel)
Amplifier Protection
Load Protection
Dimensions
Gain
20 Hz-20 kHz: 10 dB below rated power
1.0 kHz and below: full rated power
Less than 0.01%
Less than 0.01% THD
Less than 0.01% THD
20 Hz–20 kHz, ± 0.2 dB / 8 Hz–50 kHz, +0, -3 dB
Greater than 500
6 KΩ unbalanced, 12 KΩ balanced
10 Vrms (+22dB)
Variable-speed fan, rear-to-front air flow
Full short circuit, open circuit, thermal, ultrasonic, and RF protection
Stable into reactive or mismatched loads
On/off muting, DC-fault power supply shutdown
19" (48.3 cm) rack mounting, 3.5" (8.9 cm) tall (2 rack spaces),
13.25" (33.7 cm) deep (from front mounting rails)
40x (32 dB)
Weight
21 lb (9.5 kg) net
Input: 3-pin XLR & 1/4” TRS balanced
Output: Neutrik Speakon™ and touch-proof binding posts
All models All models
Continuous Average Output Power Per Channel
Bridge-Mono Mode Operation
Specifications subject to change without notice.