Filter
Top Products
9
CONNECTION
Audio connections:
Some video components are equipped with special digital
audio outputs (i.e. DVD players). If your video
component is equipped with a digital audio output, it is
recommended that you connect to the your Receiver
using a digital cable. Digital audio cables are required to
use the DTS and Dolby Digital surround sound modes. If
you do not use digital connections, your Receiver will
only operate in Dolby PRO LOGICII, PASSTHRU,
MOVIE, MUSIC, ROOM, THEATER and HALL
surround modes.
There are two types of digital cables-coaxial (75 ohm)
and optical. This Receiver is equipped with both types of
digital inputs. These inputs are labeled COAXIAL IN and
OPTICAL IN on the rear of the unit. Connect the video
component outputs to any one of the two digital inputs on
the your Receiver.
If the video component is not equipped with a digital
output, use a dual RCA to RCA composite audio cable to
connect to your Receiver. Make sure to connect:
White plug to white jack (L: left)
Red plug to red jack (R: right)
Note:
When an optical cable is used, remove the protection caps
from the component and your Receiver before attempting
to insert the optical cable. If not using an optical cable or
if the cable is removed, always re-install the protection
caps to prevent dirt and dust from entering the inputs. If
using a coaxial digital cable, leave the protection caps in
both the video component and your Receiver.
CD, TAPE JACKS
CD, TAPE jacks
Connect the component with RCA to RCA cords.
Make sure to connect:
White plug to white jack (L: left)
Red plug to red jack (R: right)
DIGITAL IN/OUT terminals
If the CD player or MD player has digital outputs,
connect the component with coaxial cables or optical
cables.
DIGITAL IN to DIGITAL OUT (CD, etc.)
DIGITAL OUT to DIGITAL IN (MD, etc.)
Connect to any one of the DIGITAL IN terminals. When
using DIGITAL OPTICAL IN terminals, remove the caps
from the terminals. When you do not use them, leave the
caps in place.
To record digitally, connect the source (CD player, etc.) to
DIGITAL IN and the recorder (MD, etc.) to
DIGITAL OUT.
AUX OUT
R L
CD PLAYER,etc.
TURNTABLE
R L