Filter
Top Products
4
Remote Control Information
1. CD Standby
When this unit is powered his buttoon, press tn to turn this unit into standby mode, press it again to power on this unit.
2. CD Display/USB
Press once to displays the current playing time and the remained time.
When there is disc inside the CD tray, press and hold this button for 2~3 seconds to switch to USB playback. Press and hold again
to switch back to CD playback. Please note that if there is no disc inside the unit, then it will switch to USB Playback automatically.
3. Repeat
Press REPEAT button once, the display will shown out REPEAT , then the track which is in play mode or ready mode will repeat
until you switch off the CD player or press STOP ( ). Press REPEAT button once more, REPEAT will shown on the display, all
tracks will be repeated until you switch off the CD player or press STOP ( ) button.
4. Random
Plays songs in random order. Press this button, the total track and the time of the CD disc shows in the display, then press
button to begin random playback.
5.
The player will skip backward each time the FastFWD button is pressed. Continuously pressing this button makes the
player scan through the tracks backward fast.
6.
Press this button to play and press it once again if you wish to pause. The relative sign will be shown on display. If in pause mode,
press this key once again to resume the operation.
7.
The player will skip ahead to the next track each time the FastFWD button is pressed. Continuously pressing this button
makes the player scan through the tracks forward fast.
8. MEM Clear: Press this key to clear all memories.
9. MEM.
Press this button at first, the MEMORY and the corresponding track will be flashed. Then press the FastFWD or FastBWD
to reach your desired track, and press MEMORY button once more to store the first track. If wishing to store the second
track, press the FastFWD or FastBWD to the second desired track and press MEMORY button to store the
second track.
Repeat the same procedure to similar settings. Continue to enter track numbers until all the pre-decided tracks are stored for
playback. Press the STOP upon finishing programming. Press PLAY button once, the different tracks that have been
stored will be played accordingly to the memories stored.
All the memory registered tracks will be cleaned if you press STOP and MEMORY simultaneously.
10. : Press this button to open or close the disc tray.
11. : Press this button to stop disc playback.
12. Intro
If you desire the Introduction Scanning, you can press INTRO button. Then each track will be scanned 10 seconds. An “INTRO ON”
will be shown on the display. Press it once again can resume the operation, and “INTRO OFF” appears on the VFD, the relative light
will gone off.
13. Numeric : Select numbers by pressing these buttons.