Filter
Top Products
_________________________________________________________- 6 -_________________________________________________
B. BACK PANEL SECTION FEATURES
1. SPEAKER JACK (LEFT/RIGHT)
These are 2 conductor 1/4” speaker outputs. Each one is rated at 8 ohm minimum impedance.
Total minimum load for the amplifier is 4 ohms. You may connect either 1-4 ohm. 1-8 ohm or 2-8
ohm speaker cabinets. Do not below rated minimum impedance.
2. SEND/RETURN
Using by this jack, you can use stereo 1/4
＂jacks connector send internal signal which before
power amplifier to external effects processing, after processing return to internal power amplifier.
Or you can use stereo or mono 1/4
＂jacks connector send external signal to inner power amplifier .
3.TAPE INPUT
These RCA jacks are for brining in a tape deck, CD play or other line level source. The
impedance is 10k ohms .
4. REC OUTPUT
These RCA jacks are for hooking up a tape desk to record from the mixer. Both channel are
summed into mono for compatibility. The signals are taken pre-master section, meaning that they are
without reverb or the master tone section, and does not include the Tape in signal, The impedance is
1K ohms @ -10dBv.
5. FAN
In order to prevent rising the inside temperature, the inside heat is emitted outside.
6. POWER SWITCH
When you want to operate, turn on it, then the LED will be turned on .