Filter
Top Products
9
OPERATION
SWITCHING ON/OFF THE UNIT
Switch on the unit by pressing any button
(except
button (7) and button (4)).
When system is on, press
button (9) to
turn off the unit.
FACEPLATE RELEASE
Press
button (7) to detach the
removable faceplate.
SOUND ADJUSTMENT
Press SEL button (10) to select the desired
adjustment mode. The adjustment mode
will change in the following order:
Pressing the VOL +/- button (11), it is
possible to adjust the desired sound
quality.
Press and hold the SEL button (10) for
several seconds to enter into the
selection for the situation of beep sound,
then press the VOL +/- (11) to select as
follows:
- BEEP 2’nd mode:
The beep is only generated when
all allowed double function button
is pressed long (several seconds).
e.g.
When preset button is pressed.
When BND/LOUD button (13) is
pressed.
When AMS button (18) is pressed.
- BEEP ALL mode:
The beep is generated when every key
is pressed.
- BEEP OFF mode:
The beep is disabled.
LOUDNESS
Press BND/LOUD button (13) for
several seconds to reinforce the bass
output. Press it for several seconds again
to release this function.
DISPLAY
Press the DISP button (15), the clock is
shown on the display. Then hold down
the button until the clock flashes. Then
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
press the button (17) to change hours
or
button (16) to change minutes.
MUTE
In radio and AUX mode, press MUTE
button (3) to mute down sound. Press it
again to release this mode and recover
previous volume level.
EQUALIZATION
Press EQ button (19) to turn on
equalization function and to select
desired audio mode. There are five kinds
of mode as below:
DISPLAY (8)
Exhibit current frequency and activated
functions on the display (8).
AUXILIARY INPUT
The unit can be connected to a portable
audio player through the AUX IN jack
(12).
REMOTE SENSOR
Point the remote control handset to the
remote sensor IR (26). Press the function
keys on the handset to control the
system.
ESP FUNCTION
If the unit has the electronic shockproof
function, it can be shockproof about
several tens of seconds.
RESET FUNCTION
RESET
button (24) must be activated
with either a ballpoint pen or thin metal
object.
The RESET button is to be activated for
the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: If press RESET button (24), the
unit can’t work yet, please use a cotton
swab soaked in isopropyl alcohol to clean
the socket on the front panel.
FLAT CLASSICS POP M ROCK M DSP OFF
BEEP 2ND BEEP ALL BEEP OFF