Filter
Top Products
125 Watts x 2
200 Watts x 2
800 Watts x 2
15 Hz-30 KHz
250mV
2.5V
14.4V DC Neg. Ground (10.5-16V)
150 Watts x 2
225 Watts x 2
900 Watts x 2
2-4 Ohms
4-8 Ohms
10K Ohms
100 Ohms
20 A 20 A x 2
281 x 59 x 381
11.06 x 2.32 x 15
281 x 59 x 432
11.06 x 2.32 x 17
when used with normal, full range systems, set these switches to “FULL.”
If you wish to use the internal crossovers to power a driver of specific
frequency range, use the “LOWPASS” or “HIGHPASS” settings.
use these controls to match the outputs of your head unit to the amplifier.
Starting with your head unit set at about the 2 o’clock position, increase
the amp level controls until distortion begins to occur, and reduce slightly
from this point.
when one or both of the crossover selector switches is in “low pass”
mode, one can set the upper frequency limit for audio program sent to
the speakers.
when the one or both of crossover selector switch is in “high pass” mode,
one can set the lower frequency limit for audio program sent to the
speakers.
this control permits adjustment of the bass level up to an increase of
approximately 18 dB in either or both pairs of channels.
this amp features gold-plated RCA input jacks for high impedance input.
Use these with car stereo output which uses RCA-type connector cables.
if your car stereo lacks RCA-type output jacks, you may connect speaker
output leads to these input connectors.
this indicator is illuminated when power is applied.
this indicator is illuminated when built-in protection circuitry is activated.
the fuse protects the amplifier and your car’s electrical system from short
circuit conditions.
use these connectors to deliver power, ground and remote turn-on control
to the amplifier.
these terminals are 14K gold plated to guarantee high conductivity and
minimum signal loss.
14
crossover mode selectors
input level controls
low pass frequency controls
high pass frequency controls
bass boost level controls
low level inputs
high level inputs
power LED
protection LED
power fuse
power terminals
speaker connections
Remote Bass Boost Plug in the Remote Bass Boost Control wire in here.
frequency response
power supply voltage
output power @ 14.4v DC, 1KHz
RMS Power @ 4 Ohms
RMS Power @ 2 Ohms
Maximum Power Output
input sensitivity
low level inputs
high level inputs
maximum current draw
dimensions (W x H x L)
mm
inches
matching speaker impedance
stereo mode
bridged mode
input impedance
low level inputs
high level inputs
PLA-2550 PLA-2650 PLA-2750 PLA-2850
281 x 59 x 482
11.06 x 2.32 x 19
281 x 59 x 532
11.06 x 2.32 x 21
200 Watts x 2
290 Watts x 2
1200 Watts x 2
300 Watts x 2
450 Watts x 2
2000 Watts x 2
25 A x 2 30 A x 2
features and specifications
2 ch amp PLA-2550 • PLA-2650
PLA-2750 • PLA-2850