PYLE Audio PCMX265B Speaker System User Manual


 
SPECIFICATIONS
Input Voltage: AC 100-120V/ 60Hz 220-240V/ 50Hz
Output Wattage: (Peak) 400W
Output Wattage: (RMS) 400W, 1%THD
Frequency Response: 70Hz~ 50kHz +/- 3dB
Bottom pole mount specifications: Standard Pole Mount found at professional audio retailer:
Depth 80mm (3.15”)
Diameter 35.5mm (1.40”)
Time required to fully charge the: under 4 hours
Battery life: Over 12 hours* at full volume of full volume of the when fully charged.
“Note: Battery life may vary based on temperature, age, and volume usage of product.
IMPORTANT NOTES
Input is clipping: Try lowering the input gain or the volume control on your sound source or music
instrument.
Output is clipping: Lower the main volume level.
There is too much bass: Try adjusting the tone or EQ control on your sound source to lower the
bass level. this will allow you to play the music louder before clipping (distortion) occurs.
The link cable: is being plugged into the instrument or MIC input instead of the RCA line input.
Use this troubleshooting guide if: The sound is distorted at high volumes.
Important: With all large speakers, initial "break-in" period is needed to perform at optimal levels.
To properly "break-in" your, play an audio source at medium volume for a few hours.