PYLE Audio FWM352 Stereo System User Manual


 
20
English
Ta pe Operation/Recording
IMPORTANT!
Before playing a tape, check and tighten
slack tape with a pencil. Slack tape may get
jammed or may burst in the mechanism.
C-120 tape is extremely thin and is easily
deformed or damaged. It is not
recommended for use in this system.
Store the tapes at room temperature and
do not put them too close to a magnetic
field (for example, a transformer, TV or
speaker).
Ta pe playback
1 Select TAPE source.
2 Open the tape key flap marked “OPEN 2” on
the front panel.
3 Press STOP•OPENÇ0 to open the tape
door.
4 Insert a recorded tape and close the tape door.
Load the tape with the open side downward and
the full spool to the left.
5 Press PLAY 2 to start playback.
The key is automatically released at the end of a
tape, except if PAUSE; has been activated.
6 To pause, press PAUSE;. Press again to resume.
7 By pressing à or á on the system fast winding
of tape is possible in both directions.
8 To stop the tape, press STOP•OPENÇ0.
Note:
The sound source cannot be changed while
playing or recording a tape.
pg001-027_M352_22_Eng 2005.12.23, 15:5320